![Yokogawa 2531 manual](https://kumkoniak.com/12.jpg)
Output settings are divided, eliminating the need for bothersome calculations for percentage output.Ĭhanges the output value in step form based on the setting from the divided output (n/m) function. Values set in steps of 4-20 mA 24V DC Power Supply to Transmitter Just open the carrying case cover and connect the cables, and you're ready to take measurements. The Handy Calibrator incorporates rotary switches for simple handling. 20 - 50☌, 90% RH or less (no condensation) Operating Temperature And Humidity Ranges 10 minutes (auto-power-off can be disabled through a DIP switch setting)Īcross input terminal and output terminal, 500 V DC, 50 MO or greaterĪcross input terminal and output terminal, 3.7 kVAC, for one minute Measurement off, output 5 V DC/10 kO or greater: Approximately 40 hours Simultaneous signal generation/measurement, output 5 V DC/10 kO or greater: Approximately 20 hoursSimultaneous signal generation/measurement, output 20 mA/5 V: Approximately 12 hours (using alkaline batteries, with backlight off)Īpprox. LED backlight auto-off after one minute (from when LIGHT key is turned on)įour AA alkaline batteries, or special AC adapter (sold separately)
![yokogawa 2531 manual yokogawa 2531 manual](https://school.ceylonbook.com/wp-content/uploads/2022/10/advanced-level-past-papers-228-900x400.jpg)
Voltage terminal: 300 V AC Current terminal: 120 mA DCĮnabled when communication cable (RS232) is connected sold separately as optional accessory Sweep time (two options: approximately 16 seconds or approximately 32 seconds)ĥ0 value sets (generated and measured values are stored as value sets with the same address (up to 50 value sets can be stored)) N value sent automatically when n/m function selection is selected (two options: approximately 2.5 seconds/step or approximately 5 seconds/step) Specification - Model CA71 Auto-Step Output Function
![Yokogawa 2531 manual](https://kumkoniak.com/12.jpg)